Face Nailing Siding

Loose siding can leave your home unprotected from weather and insects.

Face nailing siding.

The nails are covered by the board overlap in the blind nailing method while the nails are left exposed on the exterior of the boards in the face nailing method. These nails tend to be. I have been reading all the dialogue about face nailing hardi plank siding etc. Siding nail face nailing face nailing is applicable where dictated by building code in high wind areas and when fastening is to osb or equivalent sheathing without penetrating into studs.

Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation. Lift the siding up and look for nails that have been hammered in too tightly. Blind nailing is preferable to face nailing since any nail heads are hidden by the next row of siding. Next nail the first row of siding into the studs leaving 1 8 gaps at the corner boards to allow for caulking.

Hardieplank is fastened to the home by either blind nailing or face nailing. That overlap is very important when it comes to nailing techniques. The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going. Face nailing exposes the fastener head to the elements and allows for the fastener to penetrate through two sheets of overlapped.

Up off the siding. Renail the siding keeping the new nail in the center of the nailing slot and leaving it about 1 16 in. My house 9 yrs old just experienced hurricane harvey and two of the gables lost a lot of siding. In face nailing a nail is driven through the face of the board driving down through two overlapping layers into the substrate below.

What are face nails. Center joints over studs unless special metal off stud joiners are. Face nailing blind nailing measurments face nailing nailing through the overlap at the bottom of the plank for walls longer than 12 ft it is necessary to butt joint additional lengths of hardieplank siding. Loosen the tight nail or cut it with a hacksaw.

Siding is installed with slight overlap between boards a bit like the way shingles are installed.